Eurotherm 2408 Instructions d'exploitation

MC05 – 1.07 Operating Instructions Temperature Programmers Eurotherm 2408CP, 2408P4, 2408CM Including 2132 and 2116 Overtemperature Controller In

2132/2116 Overtemperature Controller 10 MC05 note: the following sections apply only when overtemperature control is fitted 6 2132/2116 – DESCRIPT

2132/2116 Overtemperature Controller MC05 11 7.1 Basic Operation Use Down q and Up p to alter the overtemperature setpoint. This should normally

2408 Controller/Programmer Copyright © 2002 Carbolite Furnaces Ltd. 8 POWER LIMIT 8.1 Overview Depending on the furnace or oven model the p

Thank you for reading this data sheet.For pricing or for further information, please contact us at our UK Office, using the details below. UK OfficeK

2408 Controller/Programmer 2 MC05 1 2408 – DESCRIPTION 1.1 Controller Nomenclature and Scope of Manual In this manual the controller is called th

2408 Controller/Programmer MC05 3 2 2408 – BASIC OPERATION 2.1 Furnace or Oven Controls Most Carbolite products are fitted with an “Instrument

2408 Controller/Programmer 4 MC05 3 2408 – PROGRAMMING 3.1 Creating a Program Note that a currently active segment cannot be altered - put the p

2408 Controller/Programmer MC05 5 3.3 Multi-program models (2408P4 & 2408CM) The Program Edit list contains the extra parameter PrG.n and th

2408 Controller/Programmer 6 MC05 3.7 Program example The following sequence of entries creates and runs the program shown graphically below. 1.

2408 Controller/Programmer MC05 7 4 2408 – NAVIGATION DIAGRAM 2 Q Q Home List Access List 20.0 %C ACCS LiSt OP 100.0 C.id 20.0 %C codE

2408 Controller/Programmer 8 MC05 5 2408 – OPTIONS Because options can be ordered in a variety of combinations and for a variety of purposes, exa

2408 Controller/Programmer MC05 9 5.4 Alarm Option When an alarm board is fitted with free contacts for customer use, the contacts are taken to